Hydraulic Oil Press Control The Direction Of Movement Of The Actuator

Aug 04, 2017Leave a message

What is the difference between a Hydraulic Oil Press and a Hydraulic Oil Press? Some people call the Hydraulic Oil Press, it was called Hydraulic Oil Press, often people are not very clear, the feeling is not too clear, the following we have to analyze what is the difference between the two.

Hydraulic machine is the name of thinking is to use oil to generate power, and hydraulic machine can not only use oil to drive, you can also use water to drive, because the water is liquid, there is a mixture of oil and gas called air compressor or gas Hydraulic Oil Press or pressurized press The So what are the roles and principles between their various parts? The hydraulic device is a hydraulic pump, hydraulic cylinder (hydraulic motor and other implementing agencies), the Hydraulic Oil Pressure is the use of Hydraulic Oil Pressure to drive the power and control of a transmission method. Control valve and hydraulic auxiliary components Hydraulic pump: conversion of mechanical energy into hydraulic energy conversion device. Hydraulic cylinder (hydraulic motor and other implementing agencies): the hydraulic energy into mechanical energy. Control valve: control of hydraulic oil flow, flow, pressure, hydraulic The working sequence of the actuator, etc. The protection of the hydraulic circuit is to control and regulate the flow, pressure and flow of the hydraulic medium, thereby controlling the direction of movement of the actuator, the force or torque of the output, the speed of movement, the sequence of actions, and Limit and adjust the working pressure of the hydraulic system to prevent overload and other effects (such as one-way valve, valve, relief valve, pressure relief valve, sequence valve, throttle valve.

The hydraulic system transforms power from one form to another. This process is accomplished by using a closed liquid as a medium. The science of transmission or transmission of motion through closed liquids is called "hydraulics", and the term hydraulics comes from the Greek "hydros", which means water. Hydraulics science is a young science - only a few hundred years old. It began in a man named Blythe Pascal found the principle of hydraulic lever transmission. This principle was later called Pascal's Law. Although Pascal made the discovery, but it was another man named Joseph Bram, in his 1795 manufacturing Hydraulic Oil Press for the first time to make the actual use of hydraulic. The liquid used as a medium in this Hydraulic Oil Press is water.

1. The Hydraulic Oil Press should be operated by hand, before the car should check the pump, hydraulic motor piping, control valve, pressure gauge is normal, confirmed correct, before operation.

2. Disconnect the power supply when disassembling the mold. Adjust the pressure head, you should first install the mold, after the installation of the mold, the hole is strictly prohibited to reach out.

3. Operators to comply with the scope of the working pressure of the Hydraulic Oil Press provisions, are not allowed to work in case of overpressure or low pressure.

4. When suppressing or correcting the workpiece, do not use the hand to hold the workpiece, do not use irregular temporary horn or round steel pressure pad correction.

5. A variety of horns to be checked. Prohibit the use of crisp hard horns. Horn should be placed in the middle, do not crooked, to prevent the pop-up wounding.

6. Hanger objects must be pad, pad stability, not allowed to stack too high, not allowed to pile on the channel.

7. All kinds of hanging, rigging must be regularly checked, within the provisions of the load range.

8. Work is completed or intermittent parking, the pressure head should be lowered, and cut off the power to ensure safety.

9. After the start of the Hydraulic Oil Press, the body is not allowed to lean on the hydraulic machine, nor allowed to stand just below the beam.