Home > News > Content
Family Use Oil Press Machine Complete The Cycle Of Various Process Actions
Aug 15, 2017

The Family Use Oil Press Machine consists of two main parts: host and control mechanism. The hydraulic machine main part includes the fuselage, the master cylinder, the ejection cylinder and the filling device. Power mechanism by the fuel tank, high pressure pump, low pressure control system, motor and various pressure valves and directional valves and other components. Power mechanism under the control of electrical equipment, through the pump and cylinder and a variety of hydraulic valve to achieve energy conversion, regulation and transportation, to complete a variety of process operations cycle.

1. The Family Use Oil Press Machine should be operated by hand, before the car should check the pump, hydraulic motor piping, control valve, pressure gauge is normal, confirmed correct, before operation.

2. Disconnect the power supply when disassembling the mold. Adjust the pressure head, you should first install the mold, after the installation of the mold, the hole is strictly prohibited to reach out.

3. Operators to comply with the scope of the working pressure of the Family Use Oil Press Machine provisions, are not allowed to work in case of overpressure or low pressure.

4. When suppressing or correcting the workpiece, do not use the hand to hold the workpiece, do not use irregular temporary horn or round steel pressure pad correction.

5. A variety of horns to be checked. Prohibit the use of crisp hard horns. Horn should be placed in the middle, do not crooked, to prevent the pop-up wounding.

6. Hanger objects must be pad, pad stability, not allowed to stack too high, not allowed to pile on the channel.

7. All kinds of hanging, rigging must be regularly checked, within the provisions of the load range.

8. Work is completed or intermittent parking, the pressure head should be lowered, and cut off the power to ensure safety.

9. After the start of the Family Use Oil Press Machine, the body is not allowed to lean on the hydraulic machine, nor allowed to stand just below the beam.

The press is a special hydraulic oil as a working medium, through the hydraulic pump as a power source, by the pump force to make hydraulic oil through the hydraulic pipe into the cylinder / piston, and then there are several sets of cylinder / piston with the seal Pieces, different locations of the seals are different, but all play the role of sealing, so that hydraulic oil can not be leaked. Finally, through the one-way valve to make the hydraulic oil in the tank cycle to the cylinder / piston cycle work to complete a certain mechanical action as a force of a mechanical. Pressure transmission is the use of liquid pressure to transmit power and control of a transmission. Hydraulic device is composed of hydraulic pump, hydraulic cylinder (hydraulic motor and other implementing agencies), hydraulic control valve and hydraulic auxiliary components Hydraulic pump: the mechanical energy into hydraulic energy conversion device. Hydraulic cylinders (hydraulic motors and other implementing agencies): the hydraulic energy into mechanical energy. Control valve: control the flow of hydraulic oil, flow, pressure,Family Use Oil Press Machine hydraulic actuator operating sequence and protection of hydraulic circuit hydraulic machine, ktc-g series - the role of hydraulic products. The popular point is to control and regulate the flow of hydraulic media, pressure and flow. Thereby controlling the direction of movement of the actuator, the force or torque of the output. Movement speed. (Such as one-way valve, valve, relief valve, pressure relief valve, sequence valve, throttle valve,Family Use Oil Press Machine speed control valve, etc.) Auxiliary components: to maintain and adjust the working pressure of the hydraulic system to prevent overload and other effects (such as check valve, 1, the tank: used to save oil, heat. Separation of oil in the air and impurities 2, tubing and tubing joints 3, oil filter 4, pressure gauge 5, sealing components